The +GF+ SIGNET 5600 Batch Controller is an extremely refined instrument that combines complex control capability with operational simplicity. Select either Simple or Advanced mode to limit feature options to suit your specific batch requirements, and make changes to batch volume quickly and easily. Two relays and one analog output provide the means to increase batch precision while dramatically reducing the possibility of water hammer in a system. Batch progress is displayed on the analog dial, while the backlit LCD is used for calibration, set-up, and to show totalized flow volumes. The controllers require 12 to 24 Volts, AC or DC, and can be used with any +GF+ SIGNET Flow Sensor with a frequency output. The intuitive software design and four-button keypad arrangement is user friendly, and the NEMA 4X/IP65 integrity of the front panel can be extended to the entire enclosure by using the optional Rear Cover Kit.

The SIGNET 8900 Multi-Parameter Controller takes the concept of modularity to the extreme. Each 8900 is field commissioned with the users specified combination of inputs, outputs, and relays using simple-to-install modular boards into the base unit. To assemble a controller, there is a choice of two base units offered with a choice of back-lit LCD or vacuum fluorescent display. Then, continue building with a selection of plug-in modules for either two, four, or six input channels which accepts any of the Signet sensors listed below, and/or other manufacturer's sensors via a 4 to 20mA signal converter (Signet Model 8058). To complete your unit, choose a power module with universal AC line voltage or 12 to 24 VDC. If more features are needed, analog output and relay modules are available and easily installed. Plus, the 8900 will support up to four additional relays via an external relay module.

The +GF+ SIGNET i-Go™ 8058 Signal Converter accepts any 4 to 20 mA signal and converts it into the +GF+ SIGNET digital format, the serial data format used by the +GF+ SIGNET 8250, 8350, 8450 and 8900 instruments. When used with the 8900 Multi-Parameter Controller, the measurement type and operating range are defined in the 8900 setup menu. When used with level, temperature and pressure transmitters, the 8058 is configured at the factory to the user's specifications.